Resolved [Xastir] Xastir, D700, and 9.6k

David Flood davidf4 at mindspring.com
Sat Oct 21 22:57:24 EDT 2006


Oops...I'll get a properly formatted one sent when I get home from work
tomorrow.

-----Original Message-----
From: xastir-bounces at xastir.org [mailto:xastir-bounces at xastir.org] On Behalf
Of David Flood
Sent: Saturday, October 21, 2006 7:54 PM
To: 'Xastir APRS'
Subject: Resolved [Xastir] Xastir, D700, and 9.6k


OK, after many suggestions and to avoid a full reset (something I'm not
quite ready to do), I took a second look at the special Kenwood command mode
and got things to work.  So here's my tnc-startup.d700.9600   I'll write up
a readme to go with it later.  

# $Id: tnc-startup.d700,v 1.6 2005/01/08 09:19:32 we7u Exp $
#
# Copyright (C) 2004-2005  The Xastir Group
#
# TNC Init file for KENWOOD D700
#
# NOTE:  TXD on a D700A is fixed at 500ms (1/2 second) in "APRS" # mode.  In
"packet" mode we can change the txd to other values. # # #Don't send
CONTROL-C before this line ##META <no-ctrl-c> TC 1 ##Pause for one second
##META <delay> ##META <delay> # Turn off APRS mode beaconing now so we don't
beacon an old position when we exit packet mode # NOTE: you will have to
manually turn beaconing back on if you leave this command enabled ##META
<no-ctrl-c> BCN 0 ##Pause for one second ##META <delay> ##META <delay> #Put
the TNC in packet mode since this is where we want to end up # Change the 1
to 0 to go to normal radio mode ##META <no-ctrl-c> TNC 2 # Pause for two
seconds ##META <delay> ##META <delay> ##META <delay> ##META <delay> #Force
9600 baud packet ##META <no-ctrl-c> PKSA 1 ##Pause for one second ##META
<delay> ##META <delay> # Enable 4800 baud GPS # Change to 2 for 9600 baud
GPS # Disable both the META line and the GU line for no change ##META
<no-ctrl-c> GU 1 # Pause for two seconds ##META <delay> ##META <delay>
##META <delay> ##META <delay> #Turn off Terminal Control ##META <no-ctrl-c>
TC 0 # Pause for two seconds just in case ##META <delay> ##META <delay>
##META <delay> ##META <delay> HID off #CWID off AWlen 8 BBSMsgs ON B E 0 LOC
E 0 Echo off FLow off AUTOLF off MCOM off MON ON MRPt on PACLen 128 PASSALL
off #HBAUD 1200 TXDELAY 25 # Delete following lines if without GPS GBAUD
4800 GPSTEXT $GPRMC LTMH OFF LTM 10 #

_______________________________________________
Xastir mailing list
Xastir at xastir.org http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir




More information about the Xastir mailing list