[Xastir] Interface Control and USB-Serial

[Jerry]

I am running Windows 7 with a Ubuntu on a Virtual box.   You might want to
try: /dev/usb0.  Virtual box had the serial port disconnected and used the
USB just fine.

Jerry N7YGE

-----Original Message-----
From: xastir-bounces at lists.xastir.org
[mailto:xastir-bounces at lists.xastir.org] On Behalf Of Matt Kassawara
Sent: Monday, October 04, 2010 8:29 PM
To: xastir at lists.xastir.org
Subject: Re: [Xastir] Interface Control and USB-Serial

The PL2303 driver will create two devices in /dev after you plug the adapter
into your computer... /dev/cu.PL2303-# and /dev/tty.PL2303-# where # is
usually an 8 digit number based on the USB port ID. 
Configure Xastir to use the /dev/cu.PL2303-# port for your TNC.  Keep in
mind that plugging the adapter into another USB port will change the #
number.

On 10/4/10 9:48 PM, Nikita Bogdanov wrote:
> Now that Xastir opens fine, the TNC does not connect, but this is most 
> likely my fault for now knowing what I am doing with my USB-Serial 
> adapter. I am using a
> PL2303 USb to serial adapter, connected a TT4 running the Byonics KISS 
> TNC firmware.
>
> Has anyone found any working entries for the "TNC Port" slot? I have 
> looked at the manual, and it states that for a Kenwood, you can enter 
> /dev/ttyS0 for Com1, but this does not work for connecting to my TNC. 
> I think that my Mac cannot see the adapter, even though I have used it
with XTerm before.
>
> I am using an FT-250R as the radio by the way.
>
> KF5EFR
>
>
>
> _______________________________________________
> Xastir mailing list
> Xastir at lists.xastir.org
> http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
_______________________________________________
Xastir mailing list
Xastir at lists.xastir.org
http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir