[Xastir] TNC setup problem

[Andrew Rich]

Eh means tnc in command mode

Your tnc is not going to tx when in command mode



Sent from my iPhone
Andrew Rich

On 19/10/2011, at 8:14, Kristen Eisenberg <kristen.eisenberg at yahoo.com> wrote:

> Hello everyone,
> 
> I have a fresh install of Fedroa14 with the latest Xastir installed. I
> have got the USB setup and TNC will work fine in normal connected packet
> mode.
> 
> I am using a KPC-2 TNC...
> 
> When I activate the TNC in Xastir with the tnc-startup.kpc2 file, I can
> not get the TNC to transmit properly for position or message packets?
> Looking at the Incoming data screen, every time the computer tells the TNC
> to transmit the TNC responds EH ? I did get a few message packets to go out
> but had to click the ³Kick the timer² button repeatedly but only a few of
> them got out without the EH ? showing up.
> 
> I am new again to Xastir but this one has me baffled as this same TNC
> ran perfect for APRSPoint just yesterday?!?!?
> 
> Hoping to get Xastir running as I am in college for IT/IS degree and have a
> Linux class starting in the fall so I am trying to hit the Linux system hard
> to be ready since I am a 44 year old Sophmore... :)
> 
> 
> Kristen Eisenberg
> Billige Flüge
> Marketing GmbH
> Emanuelstr. 3,
> 10317 Berlin
> Deutschland
> Telefon: +49 (33)
> 5310967
> Email:
> utebachmeier at
> gmail.com
> Site:
> http://flug.airego.de
> - Billige Flüge vergleichen
> _______________________________________________
> Xastir mailing list
> Xastir at lists.xastir.org
> http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir