[Xastir] Start upon Bootup

[Curt Mills]

>From page 13 of the TNC-Pi manual:

"Set the transmit delay

The transmit delay (TXDelay) can be set either in software or using R6. The
default is to set it in software. To change the TXDelay parameter, you'll
need to use the pitnc_setparams program as explained below in the section,
Using Xastir. If you set the value of TXDelay to 0 using the
pitnc_setparams program, you can then use R6 to set the TXDelay. Most users
will find the default setting for TXDelay to be just fine."


On Tue, Feb 5, 2019 at 7:58 AM Jim Darrough <jim at ki7ay.com> wrote:

> I've seen this mentioned a few times, but I need to get current and
> appropriate input on how to start Xastir upon boot of the RPi.
>
> Also have a question on how to set transmit delay so that the
> transceiver has time to develop power before the data stream starts. On
> a KPC3+ this was done by setting TXD to 60. Not at all sure how to do
> with RPi3/Pi-Tnc/Xastir.
>
> Thanks for any comments.
>
> 73 Jim Darrough, KI7AY EM25pd
>
> --
> 73 Jim,KI7AY
> la ciruela de Panama
>
> _______________________________________________
> Xastir mailing list
> Xastir at lists.xastir.org
> http://xastir.org/mailman/listinfo/xastir
>


-- 
Curt, WE7U        http://we7u.wetnet.net        http://www.sarguydigital.com