[Xastir] Start upon Bootup

[Curt Mills]

Google:

  rpi starting an app on boot

I found quite a few articles explaining multiple ways to accomplish it.


On Tue, Feb 5, 2019 at 8:17 AM Curt Mills <curt.we7u at gmail.com> wrote:

> From page 13 of the TNC-Pi manual:
>
> "Set the transmit delay
>
> The transmit delay (TXDelay) can be set either in software or using R6.
> The default is to set it in software. To change the TXDelay parameter,
> you'll need to use the pitnc_setparams program as explained below in the
> section, Using Xastir. If you set the value of TXDelay to 0 using the
> pitnc_setparams program, you can then use R6 to set the TXDelay. Most users
> will find the default setting for TXDelay to be just fine."
>
>
> On Tue, Feb 5, 2019 at 7:58 AM Jim Darrough <jim at ki7ay.com> wrote:
>
>> I've seen this mentioned a few times, but I need to get current and
>> appropriate input on how to start Xastir upon boot of the RPi.
>>
>> Also have a question on how to set transmit delay so that the
>> transceiver has time to develop power before the data stream starts. On
>> a KPC3+ this was done by setting TXD to 60. Not at all sure how to do
>> with RPi3/Pi-Tnc/Xastir.
>>
>> Thanks for any comments.
>>
>> 73 Jim Darrough, KI7AY EM25pd
>>
>> --
>> 73 Jim,KI7AY
>> la ciruela de Panama
>>
>> _______________________________________________
>> Xastir mailing list
>> Xastir at lists.xastir.org
>> http://xastir.org/mailman/listinfo/xastir
>>
>
>
> --
> Curt, WE7U        http://we7u.wetnet.net
> http://www.sarguydigital.com
>


-- 
Curt, WE7U        http://we7u.wetnet.net        http://www.sarguydigital.com