[Xastir] Print and/or screen dump

[JR]

Curt Mills wrote:

>On Sat, 25 Dec 2004, Jim R wrote:
>
>  
>
>>Curt Mills wrote:
>>
>>    
>>
>>>On Sat, 25 Dec 2004, Jim R wrote:
>>>
>>>
>>>
>>>      
>>>
>>>>I did not have /gv/, but I downloaded and installed the rpm for that (I
>>>>am running Suse 9.1).  I can run it from the command line.
>>>>
>>>>Following that, I downloaded and installed /Xastir 1.4.1/.  I chgmod
>>>>4555, and ran ldconfig just for good measure.
>>>>
>>>>
>>>>        
>>>>
>>>You re-ran "configure" so that it found "cvs" also?
>>>
>>>
>>>
>>>      
>>>
>>Curt,
>>
>>I'm not sure that I understand this question.  I am running the "stable"
>>version, not the development.  Is this still relevant?
>>    
>>
>
>Just that any time you add/subtract libraries or executables that
>Xastir can directly use, you have to go back and re-run the
>./configure step in order to pick up those changes in Xastir.  You
>of course also have to recompile/reinstall (and perhaps re-run the
>chmod command if you need that).
>
>The other poster gave a more exact answer to  your question though
>about doing the screen captures.  If you only want the map image and
>not any additional things above/below the map or other dialogs, you
>use the "snapshot" feature to do that.  Each time you enable that
>button, you'll get a fresh snapshot.  If you leave it enabled,
>you'll get a new snapshot every five minutes.
>
>  
>
Curt,

Yes, I did run ./configure, since this was a "new" install (I was 
previously running 1.4.0, but 1.4.1 creates new directories, etc.)

I tried the PNG snapshots, but get no output in /var/tmp or 
~/.xastir/tmp , neither immediately, nor after hours of running.

I'm going on a WAG here, but my hunch is that both print and the 
snapshot issues may have the same root cause, no?

Thanks,

Jim