[Xastir] GDAL and ImageMagik support for Xastir

[David Flood]

Jason,

I'm not sure about GDAL but for ./configure to "detect" Imagemagic on
Cygwin, you have to have the libxml2 files installed.  The test for
Imagemagic uses those files but Xastir doesn't.

You can check your config.status and config.log files to see why Gdal isn't
detected properly.

-----Original Message-----
From: xastir-bounces at xastir.org [mailto:xastir-bounces at xastir.org] On Behalf
Of Jason & Kim Conolly
Sent: Monday, January 10, 2005 4:30 PM
To: xastir at xastir.org
Subject: [Xastir] GDAL and ImageMagik support for Xastir


I have finally succeeded in getting a "good" Xastir install with Cygwin 
(thanks primarily to help from the Lintronix site, now referenced in the 
Readme.W32 file).  I can get Cygwin up and running, and run a basic 
configuration of Xastir.

However, I have not had any luck building Xastir with support for 
ImageMagik or GDAL.  I am using (presumably) current versions of both.  
Perhaps this is the problem?  Do I need to locate and install the older 
versions specifically listed in the Readme, or should I expect any more 
recent versions to work?  I am trying to compile Xastir with GDAL 1.2.4 
and ImageMagick 6.0.4. 

The Readme.W32 identifies ImageMagick 5.5.3 and 5.5.7 as tested with 
Cygwin.  It also calls out GDAL 1.2.0b.

Should I keep trying to work with the newer versions?

I did notice that the "recommended file list" for Cygwin has added a few 
new libraries.  Is this likely to be my problem?  I am using a complete 
file set from the Readme as it existed 11/15/04.

Thoughts?

73,
Jason / N7IME
_______________________________________________
Xastir mailing list
Xastir at xastir.org https://lists.xastir.org/mailman/listinfo/xastir