[Xastir] Xastir 1.8.5 + FreeBSD + D700 + Newbie

[Greg Eigsti]

I have added my user to the dialer and uucp groups and that does not help.

Greg

On 1/20/07 3:50 PM, "Greg Eigsti" <greg at eigsti.com> wrote:

> I am trying to get Xastir to use a serial TNC (D700) and am getting the
> following error trying to open my serial port:
> 
> Interface Error! Error opening interface 2 Hard fail
> 
> My Xastir serial TNC parameters look like:
> TNC port: /dev/cuad0
> Port Settings: 9600 bps
> Port Style: 8,N,1
> Igate Options: Allow RF to Inet traffic ONLY
> Path 1: WIDE1-1
> Path 2: WIDE2-1
> Igate -> RF path: WIDE2-1 (auto-generated by Xastir)
> Using tnc-startup.d700 and tnc-stop.d700 (appropriately edited)
> 
> I can communicate with the D700 using the following cmd - I can both change
> settings as well as display incoming RF packets...
> 
> sudo cu -l/dev/cuad0 -s9600
> 
> I am thinking that this is a permissions issue for /dev/cuad0 but am a bit
> unsure about just chmod'ing it willy nilly.  Should I execute the following
> chmod command to proceed?  I am familiar with chmod'ing files but not
> devices - don't want to mess anything up!
> 
> chmod 4511 /dev/cuad0
> 
> Help?!?!?
> 
> Thanks!
> Greg
> KD7UBJ
> 
> 
> 
> _______________________________________________
> Xastir mailing list
> Xastir at xastir.org
> http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
>