[Xastir] Interface Control and USB-Serial

[Chase Turner]

I have found luck with a Keyspan USB to Serial and nothing else.  Some
people report results with the one you mention; I am not one of them.

-Chase
W4TI

On Mon, Oct 4, 2010 at 10:48 PM, Nikita Bogdanov
<nikita_bogdanov at yahoo.com>wrote:

> Now that Xastir opens fine, the TNC does not connect, but this is most
> likely my
> fault for now knowing what I am doing with my USB-Serial adapter. I am
> using a
> PL2303 USb to serial adapter, connected a TT4 running the Byonics KISS TNC
> firmware.
>
> Has anyone found any working entries for the "TNC Port" slot? I have looked
> at
> the manual, and it states that for a Kenwood, you can enter /dev/ttyS0 for
> Com1,
> but this does not work for connecting to my TNC. I think that my Mac cannot
> see
> the adapter, even though I have used it with XTerm before.
>
> I am using an FT-250R as the radio by the way.
>
> KF5EFR
>
>
>
> _______________________________________________
> Xastir mailing list
> Xastir at lists.xastir.org
> http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
>