[Xastir] Raspberry PI 3 install instructions needed

[woodworkingman2000]

Ok,
Can you please list the exact commands you used to do the install?   I
will try again.


Thanks
-Paul H


On 10/19/18, Ken Koster <n7ipb at wetnet.net> wrote:
> On Thursday, October 18, 2018 1:10:45 PM PDT woodworkingman2000 wrote:
>> The instruction page is way out of date. For new install. Many Libs not
>> found. Can somebody update the Install page if possible.
>
> I just went through the whole process on a fresh install of raspian stretch.
>
> I did not do the shortcut but followed all the remaining instructions.  I
> did not install
> gdal.
>
> The only change necessary was to install a different package to get xset.
>
> sudo apt-get install x11-xserver-utils
>
> Even without xset the build completed without errors and xastir runs fine
> (in my
> case on a remote display since this particular pi is headless)
>
> Exactly what image are you attempting to install xastir on?  It sounds like
> it's either
> not a complete install of raspian, or some other custom image.
>
> Ken,  N7IPB
>
>> Thanks
>>
>> Also the page that give this mail list address is also incorrect.
>>
>> Using Xastir
>> To post a message to all the list members, send email to Xastir at
>> lists.xastir.org.
>> You can subscribe to the list, or change your existing subscription,
>> in the sections below.
>> Incorrrect -> lists.xastir.org
>> Correct -> xastir at lists.xastir.org
>> _______________________________________________
>> Xastir mailing list
>> Xastir at lists.xastir.org
>> http://xastir.org/mailman/listinfo/xastir
>
>
> --
> Ken - N7IPB
> Email: n7ipb at wetnet.net
> JID: n7ipb at jabber.wetnet.net
> SvxLink Repeaters: http://pnw220.wetnet.net
> PGP Sig: F42B EF90 3CD3 31C7 3056  122E 993A 7B2E 5138 C42A
> “Contrariwise,' continued Tweedledee, 'if it was so, it might be;
> and if it were so, it would be; but as it isn't, it ain't. That's logic.”
>